How We Repair Your Pool Pump
Hot tubs, saunas, steam rooms and pool equipment combine heaters, pumps, filters and controls that run in a wet, chemical-heavy environment.
Safety first: Pool and spa equipment must be on GFCI protection. Do not touch equipment if you feel tingling near the water.
Common Pool Pump Problems We Fix
Error codes on the control
Sensor, flow or heater faults.
Salt cell not producing chlorine
Scale on the cell or a cell at the end of its life.
Not heating
A failed heater element, a flow or pressure switch fault, a tripped high-limit or a gas heater ignition problem.
Pump not running or loud
A failed capacitor, worn bearings or an air lock.
Low flow
A dirty filter or a clogged skimmer or impeller.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Clean the filter
- Check water level and that valves are open
- Check the GFCI breaker
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your pool pump is doing and when it started. We schedule the first available visit.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Heater elements
- Pressure and flow switches
- Pump motors and seals
- Control boards
- Salt cells
- Sauna and steam heaters
Cost and Lifespan
Most pool pump repairs cost $150–$700 including parts and labor, and these appliances typically last 7–15 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Keep water chemistry balanced
- Clean filters regularly
- Inspect salt cells every few months
Pool Pump Repair in Selma, CA
We repair pool pumps in Selma (ZIP code 93662) and in nearby communities including Fowler, Parlier and Kingsburg. From mild coastal weather to hot inland valleys, California homes in Selma see everything from salt air to dry summer heat. Hard water is common in California, and scale is one of the first things we check on water-using appliances like this one. Near the coast, salt air speeds up corrosion on outdoor equipment, so we inspect connections and housings for rust.
Frequently Asked Questions
How much does Pool Pump Repair cost in Selma, CA?
Most pool pump repairs fall between $150–$700 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my pool pump today?
Same-day visits depend on technician availability in Selma. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Which brands of pool pump do you repair?
We repair all major brands. See the brand list on this page, or call with your model number and we will confirm.
Should I repair or replace my pool pump?
A pool pump typically lasts about 7 to 15 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.